How to Set Up Tube Light Brackets for Studio Lighting
By Kenro | Published: 2026-10-20
Category: How-to Guides
Learn how to install tube light brackets on a standard light stand for secure studio lighting. Step-by-step guide with common mistakes to avoid.
Quick answer
Mount Kenro Smart Lite Tube Light Brackets on a standard light stand by sliding the claw over the tube, tightening the clamp, and adjusting the angle before locking. Choose the 2-tube or 4-tube size based on how many lights your setup needs.
Why bracket size matters
The Kenro Smart Lite Tube Light Brackets come in two sizes: a 2-tube and a 4-tube configuration. The 2-tube bracket is lighter and easier to position on smaller stands, while the 4-tube version gives you more output but requires a sturdier stand to avoid tipping. If your light stand has a smaller top pin or is rated for less than 5 kg, stick with the 2-tube option for safety.
Both sizes use 35mm rubber-lined claws that grip the tube lights without scratching them. The rubber also reduces vibration if you adjust the bracket angle during a shoot.
Step-by-step bracket setup
- Attach the bracket to the stand: Slide the bracket's mounting base over the top pin of your light stand. Tighten the thumbscrew firmly so the bracket does not rotate or slide off. Do not overtighten the thumbscrew — it can strip the plastic threads on some stands.
- Insert the tube lights: Open each rubber-lined claw by pulling the release tab. Slide one tube light into each claw, then close the claw until it clicks. Ensure the tube is seated fully so the rubber grips the entire circumference. Check that the tube light's power cable is not pinched between the claw halves.
- Adjust the tilt angle: Loosen the tilt lock knob on the bracket, pivot the tubes to your desired angle, then retighten the knob. Use a bubble level on the tube if you need perfectly horizontal lighting. Tilt the bracket before locking — forcing it after tightening can crack the plastic housing.
- Secure cables and test stability: Route each tube light's power cable along the stand leg and secure it with a Velcro strap or cable tie. Gently shake the bracket to confirm it does not wobble. If the bracket wobbles, the stand's top pin may be too small — use a spigot adapter to increase diameter.
What you need
- Tube Light Brackets: Available in 2-tube and 4-tube configurations with 35mm rubber-lined claws. Choose the 2-tube for lighter setups or smaller stands; choose the 4-tube for more light output on a sturdy stand.
Tube Light Brackets
